Kad hocu da narezem nesto na dvd dobijem ovu poruku u nero-u "power calibration error" cd reze bez problema, , takodje ni windows nece da reze dvd samo cd, cita odlicno i jedno i drugo


nec nd 3550a, nero 8, win vista

Uradi ovo:
Otvori Control Panel, pa Administrative Tools, pa Services. Spusti se do Imapi CD Burning Com Service. Desni klik na to polje, pa Properties. Na sredini prozora, nalazi se Star tup type polje. Odaberi Disable i klikni Apply.

nema ja taj service uopste

Kako nemas? Jesi ulogovan pod admin nalogom?

naravno da jesam ali toga nema, rezao mi je do skoro ali sa nekim problemima a sad nece nikako

Idi na Start, pa kucaj msconfig, jezicak Services, nadji Imapi CD Burning Com Service. Odstikliraj ga pa Apply, i restartuj racunar.

ma kucao sam i to nema taj sevice uopste, mislim da sam ga ja obrisao ranije ali nisam siguran, evo sad sam probao jos 3 softwera i svi mi izbace isti error a obican cd rezu

Nista onda...

sad cu da probam drugi recorder pa ce vidimo 

i mene je to zezalo i na kraju samo ga (rezac) rasklopi i lepo ocisti,javi da li ti je uspelo.meni jeste

U Visti nije koriscen Imapi servis, a power calibration se pojavljuje uglavnom kada je rezac stariji, laser oslabi etc. probaj da ga ocistis, malo ces mu produziti vek. . . mozda. . . ali u svakom slucaju gledaj da zamenis rezac. . .

Meni je rezac prilicno nov,3-4 meseca ima maximalno...Optiarc je rezac...Istu gresku mi izbacuje? Nije valjda da je na izdisaju? 

Sa Nero sajta, njihovo objasnjenje.


Power Calibration is controlled by the recorder.

Before any write operation, all recorders must do a 15 step power test to determine the optimum power for writing to the CD; this is called "Optimum Power Calibration"(OPC). During the write, it continues to do this test to get the best write throughout the whole CD; this is called "Running Optimum Power Calibration" (ROPC).
This whole process is controlled by the recorder, though initiated by programs such as Nero. There is an area on the inner part of the CD for the test and test data info to be stored. You can use this area up to 999 times.

If you receive the "Power calibration error" or "Power calibration area is (amost) full" error message, the cause will be either poor media, poor power, or a defective recorder.

Please try the following solutions:

* Update the firmware of your recorder. Please check the manufacturer's website for the latest version.
* Try another brand of CD-R or CD-RW media.
* Try different power connectors, and for recorders, do not share power with other devices. It needs its own power connector. If the error occurs with an external recorder, the power source in the chassis could be the cause. As a test, try to take the recorder out of the external chassis and connect it internal.
* Try different configurations, such as taking the CD-ROM to the primary IDE bus as slave and have only the recorder connected to the secondary IDE bus as master.
* Send the recorder in for service.