Enabling java on Siemens C55

Needed tools:
[Java enabler] and [Siemens Data Exchange Software] with:
Original Siemens usb cable
or
Non-Original Siemens RS232 cable
or
Original siemens RS232 cable / 4 1,5V batteries
and a PC with a free COM1 port (on WIN2K or WINXP)

Instructions for people with an ORIGINAL Siemens USB data cable:
1. Switch off the phone
2. Connect the phone with the usb cable to the PC
3. Switch on the "charge"-button on the cable
4. Run Skylord's Unlocker (v 1.3)
5. First press the "Start" button of the unlocker program
6. Then press the "red" (on) button on the phone for a short while (don't power on!)
7. The program shall now say "Done" and display version and language
8. Finished! Now turn on the phone and use the Data Exchange Software to access the data in the phone

Instructions for people with an NON-ORIGINAL Siemens RS232 cable:
1. Switch off the phone
2. Connect the phone to COM1 with the RS232 data cable
3. Run Skylord's Unlocker (v 1.3)
4. First press the "Start" button of the unlocker program
5. Then press the "red" (on) button on the phone for a short while (don't power on!)
6. The program shall now say "Done" and display version and language
7. Finished! Now turn on the phone and use the Data Exchange Software to access the data in the phone
REMARK: If for any chance you do not recieve the "Done" message, it might be the cable problem. Try the step below

Instructions for people with an ORIGINAL siemens RS232 cable:
1. We need an 6V source for this. (you can tape 4 1,5V batteries together for this) [+ 1,5 -][+ 1,5 -][+ 1,5 -][+ 1,5 -] = [+ 6V -]
2. Tape 2 small wires at each end (put a red on the +, and a black on the - )
3. Switch off the phone
4. Connect the phone to COM1 with the RS232 data cable
5. Run Skylord's Unlocker (v 1.3)
6. First press the "Start" button of the unlocker program
7. Now slide the BLACK wire between the connector and the C55 on PIN2 and do the same on pen1 with the RED wire
8. The program shall now say "Done" and display version and language
9. Finished! Now turn on the phone and use the Data Exchange Software to access the data in the phone

Author of this tutorial is not responsable for possible damage to your phone. Your are doing everything at your own risk.